LCC Shield
Successor to the R3 version. The R4 uses an MCP2518 CAN interface IC
Create custom LCC nodes using an Arduino UNO or Mega!
- Isolated LCC Interface
This allows minimum current draw from your LCC bus. The UNO plus any loads you wish to add are powered from your UNO supply, not the LCC bus.
- DCC Receiver Circuit
This will send the isolated DCC data stream from the LCC ALT port pins to an UNO digital I/O pin. Can be disabled to gain the I/O pin for other uses.
- 256Kx8 EEPROM Included
Use the extra SPI accessible 256K memory to store CDI, data, or code.
- Factory Installed LCC ID
Includes its own unique LCC ID programmed into EEPROM by the factory.
- Flexible Power Source
Able to be completely isolated from the LCC bus and use the Arduino power supplies, or the entire Arduino plus any shield(s) can be powered from the LCC bus.
- LCC Bus Terminator
Built-in LCC bus terminator. Just set jumper to enable.
- ESD Protected CAN Port
- Inverted RJ45 jacks for easier cable removal.
- Two on-board LEDs
Two programmable LED indicators provided. Optionally, you can disable the two LEDs to gain the additional I/O pins for other uses.
- Designed to be used with LibLCC
LibLCC is a C library for LCC that runs on Arduino® and is available through the Arduino Library Manager.
This product was added to our catalog on Friday 28 June, 2024.
